External drive unit

External drive unit Drive unit with gear motor The external drive unit makes it possible to operate a tractor mixer by electric drive and it can be delivered and put into use later on. The height and tilt angle of the drive axle (PTO spline DIN 9611) can be adjusted whereby the drive can be installed in alignment with the mixer axle. A drive shaft with wide-angle joint is thus not necessary, since there is only slight angulation of the joints. Standard connection size 1 3/8” Z6 DIN 9611 (1 3/4” Z6 also available on request). There are two versions to choose from: A - Drive unit with gear motor B - Drive motor with V-belt drive Drive motor with V-belt drive For the compact drive with gear motor, an optional sliding device is also available to operate the by tractor drive as an alternative. The version with a V-belt drive is fitted with a PTO connection by the factory for tractor use. It should be noted that in this case the electric motor must be mechanically separated by removing the V-belts. Automatic time interval controls with soft start as well as a cardan drive shaft are available as accessories. We recommend the use of a frequency converter so that at any time all the components can be ideally matched to each other and adapted to the existing operating conditions. Technical data - External drive unit Hydraulic motor Hydraulic motor (standard) Hydraulic motor (reinforced) Driving mixers through an integrated hydraulic motor offers the following benefits: Retrofit installation is possible on all mixers of the  C/E-102 and E-102 ranges Two directions of rotation enable suction and pressure operation of the propeller. In this manner it is therefore possible to mix elevated slurry tanks, open slurry pits, closed deep pits and circulation systems using one and the same mixer. It is possible to fit the system to a front loader,  wheel loader and telescopic loader using the corresponding bracket. Scope of supply: Services for hydraulic drive Orbital motor with bracket, shaft coupling and welding flange. Hydraulic motor with gear stage and welded flange. The hydraulic hoses with connection fittings are not included in the price. Technical data - Hydraulic motor

Specifications are subject to change without notice.